Performance Proven Vacuum Solutions™ Reclaim/Dual Blast Module™

The reclaim/blast module consists of a Jumbo Brute system with two (2) blast pots.  A double dump vacuum intercept is mounted above the boot feed section of the bucket elevators to allow for continuous blast media recovery and reclamation.  There are two single-outlet blast pots and a storage chamber above the blast pots.  The total storage capacity is 12,000 pounds (48 cubic feet steel grit at 250 pounds per cubic foot) including blast pot capacity.  Each blast pot is equipped with metering valves, leader hoses, pinch valves, 100 feet of blast hose per blast pot, and electric Dead-man controls.  The nozzles provided are #7 type.

 Additional components and attributes of the system include: 

·          All required 1-1/2” blast pot hose and fittings.

·         1 each,10’ long “whip” hose.

·         1 each, Blast nozzle (size to be determined).

·         1 each,  Inline air filter (one outlet per pot).

·         1 each,  Blast hood with cape.

·         1 each,  Blast hood breathing air starter hose.

·        1 each,  Blast hood hose extension (if required for application).

·        25 each,  Blast hood inner lens.

·        50 each, Blast hood outer lens.

·        1 each,  Pair Gloves. 

·        One (1) 7” X 21-1/2” elevator assembly, including cast ductile iron buckets, ½” thick X 5” wide neoprene 1650# belting, top take-up and drive, with easy access doors. The unit is 11’-6” from floor level to the top of the elevator. (Note: Unit is powered by a 1 HP direct drive motor.) The capacity of this unit is 1.5 cubic feet per minute.

·        All required floor grating rated at 250 pounds per square foot.

·        All required #60 chain, sprockets, guards, seals, bearings, spacers, etc.

·        One (1) structural steel skid with forklift slots to allow easy movement of the reclaim unit.

·        One (1) 12” gravity-type air wash abrasive separator with integral perforated plate rotary drum assembly.

·        Fifteen feet of both 6” and 3” diameter metal flex trash hose.

·        One (1) 18 cubic foot abrasive storage hopper with required support steel with built-in pot riser and abrasive shut-off slide gate and attachment ring for a 24” diameter blast pot, or can be designed to feed super sacks.

·        One (1) 2’ X 4’ gravity feed “shovel-in” above grade hopper.

·        Ten feet of both 6” and 4” diameter rubber flex ducting hose.

·        One (1) 7” to 6” and 4” “Y” unit used to ventilate the air-wash unit and the elevator assembly.

·        One (1) pre-wired and interlocked NEMA 12 electrical control panel, including starters, fuses, push buttons, main line disconnect, etc. for the above proposed goods.

·        Double dump intercept devise for continuous vacuum and reclamation.

·        One (1) 600 CFM downflow dust collector, manufactured for Vector Technologies Ltd., Model Number TD2-226, including 2 HP blower, timer board, self-cleaning design, drum cover and related hardware. (Note: This dust collector is intended to ventilate the air-wash separator only.)              

For more information on the Reclaim/Dual Blast Module, contact your Vector technical representative at 1-800-832-4010. or 1 414-247-7100.